King CuttingBoard® XL is a lightweight high-density polyethylene sheet for food applications. The polymer sheet is up to 30% lighter than the solid King CuttingBoard®. It is the product of a proprietary process called K-Stran™, the most advanced manufacturing process for superior flatness and consistency. King CuttingBoard® XL has a natural matte finish on both sides of the sheet. The natural polyethylene color creates a clean and sanitary look that commercial food processing operations require. The non-porous surface does not absorb food odors and is easy to clean and sanitize.

King CuttingBoard® XL polymer sheet is NSF listed to meet requirements of commercial food processing operations for direct and indirect food contact.

King CuttingBoard® XL can be upgraded with an advanced antimicrobial technology for protecting the cutting board against stain and odor-causing microorganisms.*

Where to Buy


Standard Sheet Sizes

in: 60″ x 96″
mm: 1524mm x 2438.5mm


in: 60″ x 120″
mm: 1524mm x 3048mm

Standard Gauges

in: 1/4″ 1/2″ 3/4″ 1″
mm: 6.35mm 12.7mm 19.05mm 25.4mm

Approximate Weight 60” x 96 “

lbs: 40 lbs 80 lbs 120 lbs 160 lbs
kg: 18.14kg 36.28kg 54.4kg 72.5kg

Approximate Weight 60″ x 120 “

lbs: 50 lbs 100 lbs 150 lbs 200 lbs
kg: 22.67kg 45.36kg 60kg 90.72kg

Tolerance information:
Gauges 1/4″ up to 1” ± 5% | Length and width plus only at room temperature

Custom sizes and gauges are available

*For bacteriostatic, fungistatic, & algistatic properties. This product is exempt from registration under 40 CFR 152.25(a). Antimicrobial effectiveness verified by ISO and ASTM standards. The antimicrobial is for protecting the cutting board against stain and odor-causing microorganisms. This product does not protect users or others from food-borne bacteria. Always clean this product thoroughly after use. 99.99% effective inhibition rate has been achieved using standardized test methods of microorganism growth versus untreated controls in lab testing.

Physical Properties
Properties Units ASTM Nominal Values
Density g/cm³ D792 0.77
Tensile Strength @ Yield psi D638 >3,300
Tensile Modulus psi D638 165,000
Elongation @ Yield % D638 9.6
Flexural Modulus psi D790 130,000
Flexural Stress @ 5% Strain psi D790 2,990
Compressive Properties 10% Stain psi D695 2,910
Durometer Shore D D2240 64.9
Izod Impact Resistance ft. lbs./in.2 D256 1.4
Heat Deflection Temp. 66p.s.i. ºC (ºF) D648 87ºC (188ºF)
Screw Holding Strength lbs D1760 325

*All values are determined on specimens prepared according to ASTM standards.
Nominal values should not be interpreted as specifications.
King CuttingBoard® XL is made entirely from FDA and USDA approved material.
King CuttingBoard® XL is NSF approved for Standards 2 & 51.


Additional Information

How to Clean

Scrub the material with a strong bristle brush and professional strength detergent to remove any detritus or stains. Rinse with hot water. Sanitize with a ten percent bleach solution. Rinse thoroughly with cold water. King CuttingBoard® XL materials are dishwasher safe. Remove from the dishwasher before the drying cycle for the best result. Allow to air dry.