King Plasti-Bal®, The Heavy Duty, Waterproof and Graffiti Resistant Polymer Sheet.
- Privacy Screens
- Restroom Partitions
- Shower Enclosures
King Plasti-Bal® is offered in five matte gloss finished colors. Eleven additional colors and designer textures available upon special request. All of the King Plasti-Bal colors are environmentally friendly, which will allow you to qualify for LEED® rating points with this latest HDPE polymer sheet solution from King Plastic Corporation. The raw materials used to make King Plasti-Bal are FDA and USDA approved.
King Plasti-Bal is upgradable to King MicroShield® with an exclusive antimicrobial additive from Biosafe®, the latest technology for protecting the product surface against stain and odor causing bacteria, algae and fungi.*
King Plasti-Bal is upgradable with King FlameShield, for ASTM E-84 Class A or B Flame/Smoke Compliance and CAN/ULC-S102 for Canadian Compliance.
For more information about King MicroShield and King FlameShield, please visit those product pages.
Disclaimer: King MicroShield® may affect color. King FlameShield may affect finish and color.
Active ingredient (Biosafe®)………………….antimicrobial siloxane EPA Reg. No. 83019-1
*For bacteriostatic, fungistatic, & algistatic properties. This product is exempt from registration under 40 CFR 152.25(a). King MicroShield® effectiveness verified by ISO and ASTM standards. This product does not protect users or others from disease-causing bacteria. Always clean this product thoroughly after use.
Biosafe® is a registered trademark of BIOSAFE, Inc.: Patent number 7,851,653 and 7,858,141.
Standard Sheet Size
|in:||1″ x 55.5″ x 144″|
|mm:||25.4mm x 1409.7mm x 3657.6mm|
|in:||.950″ – .999″|
|mm:||24.13mm – 25.4mm|
Length and width plus only at room temperature
Custom sheet sizes, gauges and colors available
|Tensile Strength @ Yield||psi||D638||>4,100|
|Elongation @ Yield||%||D638||9.8|
|Elongation @ Break||%||D638||>600|
|Flexural Stress @ 5% Strain||psi||D790||3,810|
|Compressive Properties 10% Strain||psi||D695||4,950|
|Izod Impact Resistance||ft.lbs./in.2||D256||1.1|
|Brittleness Temp.||ºC (ºF)||D746||<-76ºC (<-105ºF)|
|Vicat Softening||ºC (ºF)||D1525||123ºC (253ºF)|
|Heat Deflection Temp. 66 psi||ºC (ºF)||D648||75ºC (167ºF)|
|Screw and Nail Withdrawal||lbs||D1761||657 & 63|
All values are determined on specimens prepared according to ASTM Standards.
Nominal values should not be interpreted as specifications.
King Plasti-Bal® is made entirely from FDA and USDA approved materials.
King Plasti-Bal® meets ASTM 4976.